The groundwater energy balance is the energy balance of a groundwater body in terms of incoming hydraulic energy associated with groundwater inflow into the body, energy associated with the outflow, energy conversion into heat due to friction of flow, and the resulting change of energy status and groundwater level.
Theory
When multiplying the horizontal velocity of groundwater (dimension, for example, m3/day per m2 crosssectional area) with the groundwater potential (dimension energy per m3 water, or E/m3) one obtains an energy flow (flux) in E/day per m2 crosssectional area.^{[1]}
Summation or integration of the energy flux in a vertical crosssection of unit width (say 1 m) from the lower flow boundary (the impermeable layer or base) up to the water table in an unconfined aquifer gives the energy flow Fe through the crosssection in E/day per m width of the aquifer.
While flowing, the groundwater loses energy due to friction of flow, i.e. hydraulic energy is converted into heat. At the same time, energy may be added with the recharge of water coming into the aquifer through the water table. Thus one can make an hydraulic energy balance of a block of soil between two nearby crosssections. In steady state, i.e. without change in energy status and without accumulation or depletion of water stored in the soil body, the energy flow in the first section plus the energy added by groundwater recharge between the sections minus the energy flow in the second section must equal the energy loss due to friction of flow.
In mathematical terms this balance can be obtained by differentiating the crosssectional integral of Fe in the direction of flow using the Leibniz rule, taking into account that the level of the water table may change in the direction of flow. The mathematics is simplified using the Dupuitâ€“Forchheimer assumption.
The hydraulic friction losses can be described in analogy to Joule's law in electricity (see Joule's law#Hydraulic equivalent), where the friction losses are proportional to the square value of the current (flow) and the electrical resistance of the material through which the current occurs. In groundwater hydraulics (fluid dynamics, hydrodynamics) one often works with hydraulic conductivity (i.e. permeability of the soil for water), which is inversely proportional to the hydraulic resistance.
The resulting equation of the energy balance of groundwater flow can be used, for example, to calculate the shape of the water table between drains under specific aquifer conditions. For this a numerical solution can be used, taking small steps along the impermeable base. The drainage equation is to be solved by trial and error (iterations), because the hydraulic potential is taken with respect to a reference level taken as the level of the water table at the water divide midway between the drains. When calculating the shape of the water table, its level at the water divide is initially not known. Therefore, this level is to be assumed before the calculations on the shape of the water table can be started. According to the findings of the calculation procedure, the initial assumption is to be adjusted and the calculations are to be restarted until the level of the water table at the divide does not differ significantly from the assumed level.
Shape of water table between drains
The trial and error procedure is cumbersome and therefore computer programs may be developed to aid in the calculations.
Application
The energy balance of groundwater flow can be applied to flow of groundwater to subsurface drains.^{[2]} The computer program EnDrain ^{[3]} compares the outcome of the traditional drain spacing equation, based on Darcy's law cum continuity equation (i.e. conservation of mass), with the solution obtained by the energy balance and it can be seen that drain spacings are wider in the latter case. This is owing to the introduction of the energy supplied by the incoming recharge.
See also
References

^ R.J.Oosterbaan, J.Boonstra and K.V.G.K.Rao, 1996, The energy balance of groundwater flow. In: V.P.Singh and B.Kumar (eds.), 1996, SubsurfaceWater Hydrology, p. 153160, Vol.2 of the Proceedings of the International Conference on Hydrology and Water Resources, New Delhi, India, 1993. Kluwer Academic Publishers, Dordrecht, The Netherlands. ISBN 9780792336518 . On line: [1]

^ The energy balance of groundwater flow applied to subsurface drainage in anisotropic soils by pipes or ditches with entrance resistance. On line : [2]

^ EnDrain, computer program for drainage design using the energy balance of groundwater flow, free download from : [3] , or from : [4]
External links

Articles on the energy balance of groundwater flow can be downloaded from : [5] under nr. 3 and 4.
This article was sourced from Creative Commons AttributionShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, EGovernment Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a nonprofit organization.